Extreme Networks Altitude 3550 Deployment Manual page 26

Power Tap Installation
Locate a port cover within the Part No. 15729 product package. Install the cover on the unused LAN
or WAN port and hand tighten (do not use tools).
For installations connecting to the Power Tap's "DATA IN" and "DATA PWR OUT" ports, refer to
"Cable Connectors and Unused Connector Protection" on page 27.
NOTE
Locate the earth ground boss on the back of the Power Tap. This point must be properly grounded to earth to
utilize this product's safety features. If you have not already done so, this is a good time to add the required
grounding lug or cable.
The Power Tap can be installed using the standard AP3550 mounting kit. The Power Tap can be
installed using the integrated mounting holes. The 2 holes are provided at the top and bottom of the
unit.
Proper mounting of the unit places the 10 screw-heads against the mounting surface, thus making
un-authorized installations difficult.
When mounting the Power Tap on materials such as concrete or plaster, the use of wall anchors will
provide an excellent holding grip. Use the Power Tap's 2 mounting holes as a template and punch
or drill holes to accept the 2 wall anchors.
Altitude 3550 Access Point Deployment Guide
26