Extreme Networks Altitude 3550 Deployment Manual page 22

Power Tap Installation
To install an AP3550 Power Tap:
1 Remove and retain the 10 screws used to secure the Power Tap cover.
2 Remove the weather sealing cover to expose the unit's interior. Do not remove or tamper with the
sealing gasket remaining on the back housing.
3 Remove and retain the 2 terminal screws releasing the 2 solder-less ring terminals.
4 Remove and retain the nut with a captive locking washer. This nut releases a solder-less ring
terminal.
22
Altitude 3550 Access Point Deployment Guide