GAS GAS EC 125 Racing 2013 User Manual page 33

- Pull the hydraulic rod out slowly.
- At this time, the fork oil pours out of the hydraulic
rod hole, keep it raised to let it drain until it stops.
- Install the fork spring (1) inside the fork tube.
- Tighten the suspension spring and insert the
wrench (5) in the locknut (2) to lock the cap (3).
- Install the suspension cap (3) in the fork tube
and tighten it to 29 Nm.
- Mount the other fork.
- Install the parts removed.
(1). Spring.
(2). Locknut.
(3). Suspension cap.
(4). Cap wrench.
(5). Locknut wrench.
33
-
Suspension tube spring
Different springs are available in accordance with the rider´s weight
or the road conditions.
- Harder springs make the fork stiffer, and rebound action quicker.
- Softer springs make the fork softer, and rebound action slower.
PILOT WEIGHT EQUIPPED
65+/- 75kg
75+/- 85kg *
85+/- 95kg
* SERIES
Preload: turn adjusting screw (C) clockwise as far as it will go.
See page 31.
Suspension top bridge position adjustment
Make sure the front tire does not rub against the fender when the
fork tubes are compressed fully. Make this adjustment to a minimum
of 5 mm.
The suspension tubes, both right and left, must be adjusted evenly.
-
SPRING FORCE
3,8N/m
4,0N/m
4,2N/m
CAUTION