Remove Shipping Material - Kenmore 110.4472 Series Use & Care Manual

• Ifcodes permit and a separate ground w ire isused, i tis
recommended thataqualified e lectrician determine thatthe
ground p athisadequate.
• Donotground t oagaspipe.
• Check w itha qualified electrician ifyouarenotsure the
washer isproperly grounded.
• Donothave afuse intheneutral orground c ircuit.
GROUNDING INSTRUCTIONS
For a grounded, cord-connected washer:
This washer must be grounded. In the event of a malfunction
or breakdown, grounding will reduce the risk of electrical
shock by providing a path of least resistance for electric
current. This washer is equipped with a cord having an
equipment-grounding conductor and a grounding plug. The
piug must be plugged into an appropriate outlet that is
properly installed and grounded in accordance with alI local
codes and ordinances.
WARNING: Improper connection of the equipment-
grounding conductor can result in a risk of electric shock.
Check with s qualified electrician or serviceman if you are in
doubt as to whether the appliance is properly grounded.
Do not modify the plug provided with the appliance - if it wili
not fit the outlet, have a proper outlet installed by a qualified
electrician.
For a permanently connected washer:
This washer must be connected to a grounded metal,
permanent wiring system, or an equipment grounding
conductor must be run with the circuit conductors and
connected to the equipment-grounding terminal or lead on
the appliance.
Before you install your washer, remove all shipping material.
1. To protect the floor, place two corner posts from the shipping
material on the floor in back of the washer.
2. Firmly grasp the body of the washer and gently lay it on the
corner posts.
4.
5.
o
Remove plastic foam packaging from under washer.
For Permanently Installed Compact Washers Only:
Use an adjustable wrench to turn the washer legs out
approximately 3A" (1.9 cm). This is the recommended setting.
Later adjustment may be needed.
Stand the washer up.
Remove tape from washer lid. Open washer lid and remove
foam shipping piece, parts bag and hoses from washer
basket. Remove tags from dispenser drawer. Close the lid.