Assembly - Gravely Promaster 250Z 992018 - PM 260Z Owner's/Operator's Manual

UNIT ASSEMBLY
WARNING: Make all seat adjustments with unit
stationary, parking brake on and engine shut off.
Package Contents:
Unit, Mower Deck and Literature Pack
Preparation Checklist
Refer to the Owner/Operator manual as required.
1. Unpack Unit - Remove shrink wrap and packaging
materials.
2. Remove Unit From Container - Open Bypass Valves
(dump valves) (See Moving the Unit with the Engine
Off in Operation ).
Push unit from container onto a level surface. Close
the dump valves.
3. Tires - Adjust tire pressure for front tires; 20-25 PSI
2
(138-172 kN/m ), rear tires; 12-15 PSI (83-103
2
kN/m ).
4. Position and Attach Seat - Remove nuts from seat
studs in hood frame. Peel off paper backing from
foam tape (260Z). Lift and rotate seat onto hood
frame. Secure with nuts.
5. Position Steering Levers - Remove bolts and
spacers from steering rod. Flip the steering levers
up into operating position. Reinstall spacers, bolts
and nuts. Tighten hardware securely. See Figure 4.
6. Battery - Remove battery from unit, fill with
electrolyte and charge (See Battery in
Maintenance ).
7. Check Engine Crankcase - To access engine, open
hood. Check and add oil if needed. See Engine
Manual for specifications. After service is
completed, close hood.

ASSEMBLY

2
1
1. Steering Lever in
Shipping Position
2. Spacers and
Hardware
8. 60" & 72" Decks - Remove, reverse, and reinstall
deflector and mounting bracket.
WARNING: Deflector must pivot freely. DO NOT
over tighten the pivot bolts.
9. Fill Engine Fuel Tank - Add clean fuel to the fuel
tank.
IMPORTANT: Refer to Engine Manual for fuel type.
10. Hardware - Check for loose hardware.
11. Check Safety Interlock System - Check to see that
the interlock system operates correctly.
WARNING: FAILURE OF INTERLOCK together
with improper operation can result in severe
personal injury.
12. Lubrication - Lubricate all fittings per maintenance
label under hood and check hydrostat oil level.
13. Level Deck - Check unit to assure deck level set at
factory has been maintained.
14. Check Function of all Controls - Ensure unit runs
and performs properly.
WARNING: FAILURE OF CONTROLS could
result in death or serious injury.
GB - 11
3
3. Steering Lever in
Operation Position
Figure 4
2
OF3140