Starting The Engine - Dixon ztr dx260 Operator's Manual

7. Push foot pedal fully forward for transport position.
Set the pin at the desired cutting height. (Height
selection pin is removed by rotating 180
sure that the pin is reinserted fully through the
both sides of the height panels.
the following conditions must be fulfilled before the
engine can be started:
• the blade switch for engaging the mower blades
must be depressed.
• the parking brake must be on.
• Both steering controls must be in the locked
(outer) neutral position.

Starting the Engine

1. Sit on the seat.
2. Raise the mower deck to the transport position by
setting the lift pedals fully forward.
3. Activate the parking brake.
4. Disengage the mower blades by pressing the
blade switch downwards.
28
OPeRaTION
.) Make
O
Set deck to selected cutting height
Set mower deck to the transport position
Press the control for disengaging the mower deck
8065-119
8065-017
8050-601