Kenmore 11 Owner's Manual page 17

TO CLEAN AGITATOR:
NOTE: In order to keep cleaning efficiency
high and to prevent damage to your vacu-
um, the aaitator must be cleaned every time
The agitator must also be cleaned accord-
ing to the following schedule:
Vacuum Use
HEAVY -
(used daily)
MODERATE -
(used 2-3 times/week)
LIGHT -
(used 1 time/week)
Clean Aoitator
every week
every month
every 2 months
IMPORTANT
Disconnect cleaner from electrical outlet.
Check and remove hair, string and lint build-
up frequently in the Power-Mate ® agitator
and end cap areas,
Remove any dirt or debris in the belt path
area or in the brush roller area.
Carefully remove any string or debris
located on the agitator, or end caps.
Agitator Assembly
Belt Pulley_
Brush Unit
TO REPLACE BELT
1. Install new
belt over
motor drive,
then over
brush
sprocket.
NOTE: See
PARTS AND
FEATURES
for belt number.
Motor
Drive
Sprocket
Agitator End Cap
2. Place agitator/
assembly back
into Power-
Matee.
Cover Base
4. Rotate cover
back. Press
cover firmly until
side and rear
tabs snap into
place.
Make sure there
is no gap Latch
between the cover and base.
3. Line up
front of
cover and
base. Rest
cover on
front edge of
base as
shown.
Rear
Latches
5. Turn Power-Mate®upside down and
replace two (2) cover screws.
17