Main Drive; Main Drive Timing Belt Adjustment; Main Motor Pulley Position - Ricoh C274 Service Manual

4.11 MAIN DRIVE

4.11.1 MAIN DRIVE TIMING BELT ADJUSTMENT

After the timing belt is replaced, correct belt tension must be applied.
Rear cover ( Covers / Boards - Rear Cover)
MPU ( Covers / Boards - MPU)
PSU ( Covers / Boards - PSU)
1. Loosen the screws [A], [B], and [C].
2. Move the tension roller [D] to the right with a screwdriver [E] as shown.
3. Tighten the screws [A], [B], and [C].
4. Remove the screwdriver.

4.11.2 MAIN MOTOR PULLEY POSITION

After putting the pulley back on the main motor shaft, refer to the above illustration for the
correct position of the pulley.
SM
CÓPIA NÃO CONTROLADA
4-45
CÓPIA NÃO CONTROLADA
Main Drive
C274