Timing Adjustment - Ricoh C274 Service Manual

Paper Delivery
Rear cover ( Covers / Boards - Rear Cover)
1. Loosen screw [A] then screw [B] in this order (do not remove them). Make sure that the
bracket [C] becomes free from engagement and the cam follower [D] contacts the
drum flange.
2. Using a gap gauge, measure the clearance [E] between the drum surface and the exit
pawls. It should be 1.15 ± 0.15 mm.
3. If the clearance is not correct, adjust the clearance by turning the bolt [F].
4. Reposition the bracket [C] and tighten the screws [A] and [B].
5. Do the timing adjustment (see the next section).

Timing Adjustment

Standard: 0 or less than 0.5 mm
C274
CÓPIA NÃO CONTROLADA
4-42
CÓPIA NÃO CONTROLADA
SM