Scientific Atlanta Explorer 1850 User Manual page 9

8300HD Back Panel Overview
1 Cable in
2 Cable Out
3 PrPbY/V
4 Digital Audio Output
5 Secondary Video
and Audio Out
6 Audio Out (L and R)
7 Optical Audio
Output
8 S-Video Out
9 HDMI
10 IR
11 SATA
12 1394 FireWire
13 AC Outlet
14 AC Power Input
Connects to the coaxial cable coming from the wall.
Connects a coaxial cable to Cable Out to send analog audio and video signals to a
TV or VCR. These signals are SDTV video and stereo audio.
Connects the 8300HD (when in HD mode) to the component video input (YPrPb)
on the HDTV. When the 8300HD is configured for SD mode, the Y/V portion of the
component video output connects to the composite video input of an HDTV or SDTV.
See required connections for an HDTV or required connections for an SDTV on pages
40–57 for complete details.
Connect an RCA cable to send a digital audio signal to a surround-sound receiver
or other digital audio device.
Connect to either a VCR for archiving saved content from the
8300HD or to another set of inputs (composite) on your HDTV.
Connect RCA cables to Audio Out to send analog audio signals (left and right) to a
stereo receiver or a TV with stereo outputs.
Connect an optical cable to send a digital audio signal to
surround-sound receiver or other digital audio device.
Connect an S-Video cable to send an S-Video signal to your TV or VCR. This signal
is standard definition but higher quality than other SDTV connections.
Connect the HDTV HDMI™ connector to the HDMI port. HDMI supports both digital
audio and video. May be used to connect to a DVI interface using an adaptor.
(This connector reserved for future use.)
Connect to an external Serial ATA (SATA) hard disk drive for expanded recording
capability. Please check with EATEL for a list of approved hard drive models for use
with the 8300HD.
Connect to display devices equipped with a 1394 (FireWire) input. This connector is
reserved for future use and may not be available on all 8300HD models.
Connect the AC power cord from another device, such as a TV.
Connect the STB to an AC electrical outlet using the cord provided.
Continued on Next Page
35