Service Interval Display - Skoda Fabia Owner's Manual

Current speed
The current speed, identical to the display on the speedometer
page 10, is displayed.
Oil temperature
1)
The current engine oil temperature is displayed. If the oil temperature is lower
than 50 °C or if a fault in the system for checking the oil temperature is present,
only - -.- is displayed instead of the oil temperature.
Warning against speeding
The warning that the speed limit is being exceeded can be enabled/disabled in
the display » page 16.
Warning against speeding

First read and observe the introductory information and safety warn-
ings on page 13.
Adjust the speed limit while the vehicle is stationary
›
Press button » Fig. 5 on page 14 to select the Warning at (MAXI DOT display)
A
or  (segment display) menu item.
›
Press button to activate the ability to set the speed limit
B
›
Use the button to set the required speed limit, e.g. 50 km/h.
A
›
Confirm the speed limit that was set with button
until the setting is saved automatically (the value stops flashing).
This allows you to set the speed in 5 km/h intervals.
Adjusting the speed limit while the vehicle is moving
›
Press button » Fig. 5 on page 14 to select the Warning at (MAXI DOT display)
A
or  (segment display) menu item.
›
Drive at the desired speed, e.g. 50 km/h.
›
Press button to accept the current speed as the speed limit (the value flash-
B
es).
If you wish to adjust the set speed limit, you can do so in 5 km/h intervals (e.g. the
accepted speed of 47 km/h increases to 50 km/h or decreases to 45 km/h).
›
Confirm the speed limit that was set by pressing button
prox. 5 seconds until the setting is saved automatically (the value stops flash-
ing).
1) Applies for vehicles equipped with the MAXI DOT display.
2)
An initial value of 30 km/h is displayed automatically if no value has been specified.
16
Using the system
» Fig. 2 on
3

(value flashes).
2)
, or wait approx. 5 seconds
B
again, or wait ap-
B
Change or delete speed limit
›
Press button » Fig. 5 on page 14 to select the Warning at (MAXI DOT display)
A
or  (segment display) menu item.
›
Pressing button disables the speed limit.
B
›
Pressing the button activates the ability to change the speed limit.
B
If the set speed limit is exceeded, an audible signal will sound as a warning. The
Warning at (MAXI DOT display) or  (segment display) menu item appears in the
display with the limit set.
The speed limit set mode is stored even after the ignition is switched off and on.

Service Interval Display


Introduction
This chapter contains information on the following subjects:
Prompt in the segment display
Display in the MAXI DOT display
A message concerning the kilometres and days remaining until the next service
is due is shown for about 10 seconds after the ignition is switched on until the
end of the service interval is reached.
The kilometre indicator or the days indicator reduces in steps of 100 km or days
until the service due date is reached.
Note
Information is retained in the Service Interval Display even after the vehicle bat-
■
tery is disconnected.
If the instrument cluster is exchanged after a repair, the correct values must be
■
entered in the counter for the Service Interval Display. This work will be done by a
specialist garage.
For more information on the service intervals
■
17
17
» page 145, Service intervals.

