Kärcher K 6.75 M User Manual page 9

Special accessories
Special accessories expand the possibili-
ties of using your appliance. Please contact
your Kärcher dealer for further information.
Before Startup
Mount loose parts delivered with appliance
prior to start-up.
Illustrations on fold-out pag-
es!
Illustration
Tools needed for installation (not supplied)
Illustration
Î Attach the accessory holder to the de-
vice.
Illustration
Î Attach the transport handle.
Î Insert holder for trigger gun.
Illustration
Î Attach the quick coupling to the water
supply hose.
Illustration
-Attach support leg.
Illustration
Î Attach expanding rivet to axle.
Î Insert expanding rivet to axle.
Illustration
Î First push the transport wheel, and then
the sleeve onto the axle.
Illustration
Î Insert the axle into the bearings.
Illustration
Always hold against axle when performing
the following steps.
Î First push the sleeve and then the
transport wheel onto the axle.
Î Attach expanding rivet to axle.
Î Insert expanding rivet to axle.
Illustration
Î Attach the wheel caps.
Illustration
Î Push the high pressure hose into the
trigger gun until it locks audibly.
Note: Make sure the connection nipple
is aligned correctly.
Î Check the secure connection by pulling
on the high-pressure hose.
Water supply
According to the applicable regula-
tions, the appliance must never be
used on the drinking water supply
without a system separator. Use a
suitable system separator manufactured by
Kärcher; or, as an alternative, a system
separator as per EN 12729 Type BA.
Note: Impurities in the water can damage
the high-pressure pump and accessories.
For protection, the use of the Kärcher water
filter (optional accessory, order no. 4.730-
059) is recommended.
Water supply from mains
Observe regulations of water supplier.
For connection values, see type plate/tech-
nical data.
Î Unwind the garden hose from the hose
drum.
Î Connect the quick coupling of the water
hose to the water tap.
Drawing in water from open reservoirs
When fitted with the appropriate accesso-
ries, this high-pressure cleaner can draw in
surface water, e.g. from water butts or
ponds (max. suction height 0.5 m).
Illustration
Î Remove the water inlet hose from the
appliance.
Î Unscrew suction hose connection cap.
Î Place cap on water connection and turn
by 90° until it locks into place.
Î Attach Kärcher suction hose with filter
(Optional accessory, order no. 4.440-
238) to the suction hose connection and
suspend into the rain barrell.
Î Remove air from appliance before oper-
ation.
Switch on the appliance without mount-
ed spray lance and run it until the water
discharging from the trigger gun is free
of bubbles. Switch off appliance and
connect spray lance.
Note: Fill suction hose with water be-
fore use, this will help ventilate the
pump of air.
17
English