Initial Start-Up/Operation - MULTIQUIP SideWinder HS62A Operation And Parts Manual

INITIAL START-UP
CAUTION
DO NOT attempt to operate the saw until the Safety, General
Information and Inspection sections of this manual have been
read and thoroughly understood. Depending on engine
manufacturer, operating steps may vary. See engine
manufactures operating manual.
CAUTION
NEVER operate the saw in a confined area
or enclosed area structure that does not
provide ample free flow of air .
ALWAYS wear approved eye and
hearing protection before operating the
saw.
NEVER place hands or feet inside the belt
guard or blade guard while the engine is
running. ALWAYS shut the engine down
before performing any kind of
maintenance service on the saw.
Explosive Fuel
Fuel Check
Motor fuels are highly flammable and can be
dangerous if mishandled. DO NOT smoke
while refueling. DO NOT attempt to refuel the
saw if the engine is hot! or running .
1. Remove the fuel cap located on the side of the saw.
2. Visually inspect to see if fuel level is low. If fuel is low,
replenish with fuel oil mixture as shown in Figure 13.
3. When refueling, be sure to use a strainer for filtration. DO
NOT top-off fuel. Wipe up any spilled fuel.
This saw uses a 2-stroke engine which
requires a mixture of premium 92 octane
NOTE
unleaded gasoline and smoke free 2-stroke
motor oil. See Figure 13.
HS62A CUT-OFF SAW — OPERATION & PARTS MANUAL — REV. #0 (10/20/06) — PAGE 19
HS62A CUT-OFF SAW — INITIAL START-UP/OPERATION
Figure 13. Fuel to Oil Mixture
For correct fuel to oil mixture, add 2.6 fl. oz
(29.6 ml) of 2-stroke motor oil to 1 gallon (3.8
liters) of premium 92 octane unleaded
NOTE
gasoline . For a 5 gallon can of premium
unleaded gasoline add 13 fl. oz (384 ml) of
2-stroke motor oil.
A bottle ( 2.6 fl. oz) of smokeless 2-stroke motor oil cannot be
purchased separately . Only a case of 36 individual bottles can
be purchased. When ordering use Multiquip P/N 00325.
Starting
1. Place the engine ON/OFF switch in the ON position
2. Using your thumb, press down on the throttle lock lever,
while squeezing the throttle trigger. This will lock the throttle
in the half-throttle position.
3. Pull the choke lever all the way out to the CLOSED position.
4. Pull the decompression button inward.
5. Place the saw on level ground. Make sure the saw blade is
free to rotate and will not come into contact with any foreign
objects.
6. Hold the front handle firmly with the left hand and put your
right foot onto the base of the rear handle.
The CLOSED position of the choke lever
enriches the fuel mixture for starting a COLD
NOTE engine. The OPEN position provides the
correct fuel mixture for normal operation after
starting, and for restarting a warm engine.