Operation - MULTIQUIP TP24X Operation And Parts Manual

START-UP PROCEDURE
NOTICE
Read and fully understand this manual before
starting or attempting to operate the saw.
Before starting the saw's electric motor
make sure that the Safety, General Information, and
Set-Up sections have been completed and understood.
DO NOT proceed until the above mentioned sections
have been completed.
WARNING
Adherence to the OSHA 2017 Ruling governing
Occupational Exposure to Respirable Crystalline
Silica, requires that all sawing operations MUST BE
conducted with an integrated water delivery system
that feeds water to the blade.
WARNING
ALWAYS wear approved eye and hearing
protection before operating the saw.
WARNING
NEVER place hands or feet inside the belt
guard or blade guard while the motor is
running. ALWAYS shut the motor down
before performing any kind of maintenance
WARNING
NEVER place hands and fingers near
the cutting blade. The possibility exists of
severe bodily harm if hands and fingers
come in contact with rotating saw blade.
WARNING
ALWAYS ensure that the cutting blade has
been mounted correctly.
PAGE 22 — TP24X TILE SAW • OPERATION AND PARTS MANUAL — REV. #4 (09/12/19)
WARNING
NEVER lift the blade guard while the blade
is rotating. The possibility exists of severe
bodily harm if fingers or hands come in
contact with the rotating saw blade. Wait
for the blade to stop rotating before lifting
the blade guard.
DANGER
NEVER touch a live power cord with wet
hands. The possibility exists of electrical
shock, electrocution which could cause
severe bodily harm, even death.
1. Place the material to be cut (Figure 15) on the cutting
table against the backstop.
Figure 15. Material Placement
DANGER
ALWAYS be alert to the fact that there is a rotating
blade on the saw and be extremely aware of your body
position — especially your hands in relationship to the
rotating blade. The possibility exists of severe bodily
harm or even death if your body comes in contact with
the rotating saw blade.

OPERATION

CUTTING
TABLE
MATERIAL
BACKSTOP