Maintenance - MULTIQUIP SideWinder HS62A Operation And Parts Manual

V-Belt Changing Procedure
N
Figure 14. Belt Guard Cover Removal
Figure 15. Re-Installing Cover Guard
Figure 16. V-Belt Tensioning
Figure 17. Drive V-Belt
HS62A CUT-OFF SAW — OPERATION & PARTS MANUAL — REV. #0 (10/20/06) — PAGE 21
HS62A CUT-OFF SAW — MAINTENANCE
Remove the 2 hex nuts
gain access to the V-belt on the clutch side. Remove V-belt
cover .
Remove the 2 hex nuts
knob to gain access to the V-belt on the spindle side. Remove
the Cover Guard
Using the provided wrench, loosen the three nuts
the tension on the V-belt, then turn the V-belt Tensioning Cam
until the V-belt is completely slacked.
Remove the V-belt
Install the new V-belt around both pulleys. It is essential that the
drive V-belt is properly positioned around both the clutch and
spindle pulleys.
and hex screw and washer
and hex screw and guard adjustment
.
from the clutch and spindle pulleys .
to
to reduce