Table of Contents
Advertisement
INTRODUCTION TO YOUR NEW
R 401 Series A • R 402 Series A
• R 402 V. Series A
BOWL CUTTER / VEGETABLE
PREPARATION ATTACHMENT
The food processor is perfectly geared to your
professional needs. It can perform any number of
tasks to meet all your professional needs.
The R 401 Series A - R 402 Series A - R 402 V
Series A consists of a cutter bowl and a vegetable
preparation attachment. With the cutter bowl, the
R 401 Series A - R 402 Series A - R 402 V Series A
can be used to process meats, vegetables, fine stuf-
fing, and mousse. Grinding, chopping, kneading,
and pureeing are all possible, and most operations
can be performed in 3 minutes or less. A wide
range of cutting plates is available for use with the
vegetable preparation attachment. Slicing, grating,
and julienne operations can all be achieved with the
vegetable preparation attachment.
Additionnal cuts are available on the R 402 Series
A and the R 402 V Series A : dicing and French
fries.
The numerous functions will open the door to a
whole new culinary world.
Thanks to its simple design, all components requiring
frequent handling for maintenance or cleaning can
easily be removed for cleaning and maintenance.
This manual contains important information desi-
gned to help you get the most out of your R 401
Series A - R 402 Series A - R 402 V. Series A cutter
bowl/vegetable preparation device.
We therefore recommend that you read it carefully
before using your machine.
We have also included a few examples to help you
get the feel of your new machine and appreciate its
numerous advantages.
6
SWITCHING ON THE MACHINE
• ADVICE ON ELECTRICAL CONNECTIONS
Before plugging in, check that your power supply
corresponds to that indicated on the machine's
serial number plate.
W A R N I N G
This appliance must be plugged into a
grounded socket (risk of electrocution).
Your R 401 Series A - R 402 Series A - R 402 V
Series A is fitted with a single phase motor.
It comes with a power supply cord which plugs into
a standard 120V/60Hz, 15 Amp grounded power
outlet.
• CONTROL PANEL
R 401 Series A
Red switch
=
Off switch
Green switch =
On switch
Black switch
=
Pulse control
1 speed 1725 rpm
R 402 Series A
Red switch
=
Off switch
Green switch =
On switch
Black switch
=
Pulse control
Speed selector 550 or 1645 rpm
R 402 V. Series A
Red switch
=
Off switch
Green switch =
On switch
Black switch
=
Pulse control
Speed control = 300 - 3600 rpm with cutter
bowl 300 - 1000 rpm with Vegetable preparation
attachment.
• CUTTER BOWL ATTACHMENT
1) With the motor base
facing you, place the bowl
onto the motor base with the
handle toward the front.
Turn the bowl just off-center
and to the left as you lower
it onto the base.
2) Then, turn the bowl back
to the right (counterclockwi-
se) locking it onto the motor
base tabs.
3) Place the blade assembly
onto the motor shaft. Rotate
the blade assembly until it
drops into place. The bot-
tom blade should be level
with and just off the bottom
of the bowl.
4) Note the plastic tab on
the bowl lid. Place the lid on
the bowl with the tab turned
to the front and slightly to
the left of the bowl handle;
then, turn the lid back to the
right until it comes to a stop
with the tab over the bowl
handle.
The device is now ready for use.
ASSEMBLY
Advertisement
Table of Contents
