Installing The Engine - Yamaha BT1100 2002 Service Manual

4
5
3
2
1
a
EASB0014

INSTALLING THE ENGINE

1. Tighten the bolts in the following order:
2
1 CAUTION:
Install the Ø 12mm washer under the head of
bolt 2.
2. Install:
NOTE:
• Align the punch mark in the shift shaft with the
• Install the shift rod joint pin in the shift pedal.
3. Check:
4-5
ENGINE
Bolt 1:
65 Nm (6.5 m•kg)
Bolt 2:
65 Nm (6.5 m•kg)
Nut 3:
85 Nm (8.5 m•kg)
Special screw 4:
18 Nm (1.8 m•kg)
Bolt 5:
110 Nm (11.0 m•kg)
• shift arm 1
slot 2 in the shift arm
Refer to "ADJUSTING THE SHIFT PEDAL" in
Chapter 3.
Shift arm bolt
10 Nm (1.0 m•kg)
• shift pedal position
(distance a from the top of the rider footrest
to the top of the shift pedal)
Out of specification
Shift pedal position
(below the top of the rider footrest)
45 mm
ENG
Adjust.