Reclining Seat - Pride Mobility Jazzy 1103 Ultra Owner's Manual

V . C O M F O R T
12. Reinstall each screw into the trapeze bars and tighten.
13. Reinstall the seat.
14. Reconnect the controller to the power pod.
15. Reinstall the rear shroud.
Seat Position
You can move the seat forward or rearward by changing
the extrusion mounting position.
To change the position:
1. Unplug the motor connectors, battery connector, and
charger inhibit.
2. Remove the seat from the power base.
3. Remove both extrusions from the bottom of the seat.
4. Reposition the extrusions on a different set of mounting
holes. You must move both extrusions the same number
of holes either forward or backward. See figure 13.
5. Fasten the extrusions back onto the bottom of the seat.
6. Reinstall the seat.
Seatback Angle Adjustment
If your power chair is equipped with an adjustable seatback,
you can adjust it to four (4) different angles: 90°, 102°,
105°, or 107°.
To adjust the seatback angle:
1. Remove the adjusting screws from each seat hinge. See
figure 14.
2. Set the seatback at the desired angle.
3. Reinstall the adjusting screws to each seat hinge and tighten.

Reclining Seat

If your Jazzy 1103 Ultra is equipped with a reclining seat,
you can adjust the seatback angle with the seatback release
lever. The lever is located on the right side of the seat base.
See figure 5.
To adjust the recline angle:
1. Push down on the seatback release lever.
2. Lean forward or backward to the desired position.
3. Release the lever.
Armrest Width Adjustment
You can change each armrest’s width independently of the other.
22
A D J U S T M E N T S
ARMREST ANGLE
ADJUSTING
SCREW
JAM NUTS
SEAT HINGE
www.pridemobility.com
Figure 13. Seat Mounting Holes
SEATBACK
ANGLE
ADJUSTING
SCREW
ARMREST KNOB
Figure 14. Seatback Angle Adjustment
Jazzy 1103 Ultra/RevB/Feb04