Weslo WLEX61211.0 User Manual page 8

4. Remove all parts from the Pivot Axle (3).
Using a small plastic bag to keep your fingers
clean, apply some of the included grease to the
Pivot Axle (3) and to the indicated locations.
Insert the Pivot Axle (3) into the Frame (1), and
align the hole in the center of the Pivot Axle with
the hole in the center of the Frame. Then,
tighten an M5 x 16mm Machine Screw (58) into
the Frame and the Pivot Axle.
Slide the Left and Right Upper Handlebars (40,
41) onto the ends of the Pivot Axle (3).
Next, slide an M8 Washer (38) onto each end of
the Pivot Axle (3), and tighten an M8 Locknut
(9) onto each end of the Pivot Axle at the same
time. Make sure that at least two threads on
each end of the Pivot Axle extend past each
Locknut. In addition, make sure that the
Upper Handlebars (40, 41) move freely.
Next, press a Pivot Cap (50) onto each end of
the Pivot Axle (3).
5. The Console (7) can use four AA batteries (not
included); alkaline batteries are recommended.
Do not use old and new batteries together or
alkaline, standard, and rechargeable batteries
together. IMPORTANT: If the Console has
been exposed to cold temperatures, allow it
to warm to room temperature before insert-
ing batteries. Otherwise, you may damage
the console displays or other electronic
components. Remove the battery cover from
the back of the console, and insert batteries into
the battery compartment. Make sure to orient
the batteries as shown by the diagram inside
the battery compartment. Then, reattach the
battery cover.
4
40
50
9
38
1 58
Grease
5
7
8
41
Grease
3
38
9
50
Grease
Battery
Compartment