Clear Voicemail; To Manually Turn Off The New Voicemail Indicator; Handset Reset; Base Settings - VTech DDA200BT User Manual

Clear voicemail

If you subscribe to voicemail service offered by your telephone service provider, new voicemail and <VOICEMAIL icon> appear
on the handsets when you have new voicemail messages. Contact your telephone service provider for more information and
assistance about using your voicemail service. This feature only works on the voicemail associated with your home line, not the
cell line.
After you have listened to all new voicemail messages, the indicators on the handsets turn off automatically.
Use the clear voicemail feature when the telephone indicates that there is new voicemail but there is none (for example, when
you have accessed your voicemail while away from home). Clearing the voicemail waiting indicator only turns off the indicators;
it does not delete your voicemail messages. As long as you have new voicemail messages, your telephone service provider
continues to send the signal that turns on the indicators

To manually turn off the new voicemail indicator:

1. In standby mode, press MENU/SELECT then UP/DOWN to select Settings.
2. Press MENU/SELECT then UP/DOWN to select Clr voicemail
3. Press MENU/SELECT. The display shows Turn off indicator? Press OK to confirm.
4. Press MENU/SELECT to confirm. Or press END CALL/CLEAR to cancel the procedure.
Note: For information about using your voicemail service, please contact your telephone service provider.
Your telephone service provider might alert you to new voicemail messages with a stutter (broken) dial tone. Contact your
telephone service provider for more details

Handset reset

1. In standby mode, press MENU/SELECT then UP/DOWN to select Settings.
2. Press MENU/SELECT then UP/DOWN to select Reset.
3. Press MENU/SELECT then use the keypad to enter 4-digit PIN (default 4-digit PIN is 0000).
4. Press MENU/SELECT. The display shows Reset to default settings?
5. Press MENU/SELECT to confirm. Or press TALK OFF/CLEAR to return to previous level.

Base settings

Set the flash (recall) time

The default flash (recall) time is 100MS. It is unlikely that you should need to change this setting unless advised to do so.
1. In standby mode, press MENU/SELECT then UP/DOWN to select Settings.
2. Press MENU/SELECT then UP/DOWN to select Flash time.
3. Press MENU/SELECT then UP/DOWN to select the flash time from 80ms, 100 ms, 120 ms, 180 ms, 200 ms 250 ms, 300 ms
and 600 ms.
4. Press MENU/SELECT to save.

Change system PIN

1. In standby mode, press MENU/SELECT then UP/DOWN to select Settings.
2. Press MENU/SELECT then UP/DOWN to select System PIN.
3. Press MENU/SELECT then use the keypad to enter old 4-digit PIN (default 4-digit PIN is 0000).
4. Press MENU/SELECT then use the keypad to enter new 4-digit PIN.
5. Repeat step4 to enter the new 4-digit PIN again.
6. Press MENU/SELECT to confirm.
26