Toshiba PORTEGE A200 series Maintenance Manual page 195

3.30 SETUP
8. Configuration
This option lets you set the device configuration.
All Devices
Setup by OS
Note: When using installed OS, selecting "Set by OS" is recommended. But, when
setting "PC CARD-Controller Mode" to other than " Auto-Selected", select
"All Devices".
9. Drives I/O
This option displays the address and interrupt level for hard disk drive and optical disk
drive. It is for information only and cannot be changed.
Built-in HDD
CD-ROM
PC-card
10. PCI Bus
This option displays the interrupt level for the Card Bus in the computer. It is for information
only and cannot be changed.
PCI BUS
11. PC Card
This option displays the PC Card Controller mode. When "Device Config." is set to "All
Devices", it can be changed.
Auto-Selected
PCIC Compatible
PORTEGE A200 Maintenance Manual (960-499)
BIOS sets all devices.
Initializes devices, which is needed to load an operating
system. Operating system initializes other devices. When
this option is selected, the setting in the "PC Card"
becomes "Auto-Selected" and it can not be changed.
(Default)
This cannot be changed.
This cannot be changed. This is not displayed when a drive
is not built-in.
Displays an address and interrupt level only when the
system has been booted by a PC-card type HDD.
= IRQ10, IRQ11
Use this setting when OS supports Plug&Play. (Default)
Use this setting when Card Bus does not work properly in
"Auto-Selected" or PC card supports 16-bit.
3 Tests and Diagnostics
3-97