Troubleshooting Guide - Star Micronics LC-240C User Manual

Troubleshooting guide

Use the following table to help track down the causes of problems and to determine the
best solution to deal with them.
Problem
The READY indicator does
not light or flash.
Printer sounds like it is
printing, but it is not.
Printing is weak.
Printer test works, but printer
will not print out data from
the attached computer.
Possible Cause
The printer is not receiving
power.
The ribbon is jammed,
twisted, or not set correctly
between the print head and
the print head shield.
The printer is not set up
correctly for the thickness of
paper you are using.
The wrong emulation is
selected.
Your application program's or
system software's printer
selection is wrong.
The computer's system
software is not set up
properly for the printer or for
the type of interface cable
you are using.
Troubleshooting guide
Recommended
Action
Check whether the power
cord is correctly plugged into
the power outlet.
Check whether the power
outlet is working by
unplugging the printer and
plugging in another device.
Make sure that the ribbon
cartridge is installed
correctly. See "About ribbon
cartridges" on page 5.
Set up the printer for the
paper thickness you are
using. See "Adjusting for
paper thickness" on page 40.
Check the emulation
selection and change if
necessary. See "Emulation"
on page 20.
Check the printer selection
of your application software.
Check the system software
settings.
49