Starting Up The User Setup Utility - Star Micronics LC-240C User Manual

Starting up the User Setup Utility

To start up the User Setup Utility, move to the directory you specified under
"Installing the User Setup Utility" on page 15. If you want to move to the
directory we named "star" in our example in the previous section, you
would input the following:
C:\>cd star ↵
Next, input the command to launch the User Setup Utility:
STARSET ↵
When you start the User Setup Utility, it reads and displays the printer's
current settings.
Now you can use the pull-down menus described below to make the setup
changes you want.
If the printer is not connected to your computer or if the power of the printer is
switched off, the following mesage appears on the display when you start up the
User Setup Utility.
Check the connection between the computer and the printer, and check the
power. After correcting the problem, press Enter to continue.
The above message also appears when your computer and printer are connected
through and optional Serial-To-Parallel Interface Converter. In such a case,
simply press the computer's ESC key to clear the message.
Exit Load Save General
Emulation (•) Standard
( ) IBM
Graphic (•) Uni-direction
Direction ( ) Bi-direction
A.E.C. (•) Enabled
( ) Disabled
Ink (•) Color
color ( ) Monochrome
Current Data: Current General Setting
TAB = Next Box = Scroll up
SPACE = Set Function = Scroll down
Printer is not answering !
Please check the power and interface cables
= Retry
Starting up the User Setup Utility
Font Paper Adjust.
RAM (•) Input Buffer
*
usage ( ) Download
Sleep (•) 15 min.
*
( ) 30 min.
Demo (•) Self-print short
*
Print ( ) Self-print long
Default (•) Black
*
color ( ) Red
and try again
ESC = Cancel
Port Help
*
*
*
*
= Menu Select
17