Table of Contents
Advertisement
Z WARNING
If you smell gas:
• Shut off gas supply to the gas grill.
• Turn the Control Knobs to OFF position.
• Extinguish any open flame such as candle,
cigarette, lighter, etc., that could cause gas
to ignite.
• Open the Grill Lid.
• Get away from the LP gas tank.
• Do not try to fix the problem
yourself.
• If odor continues
or you have a fire you
cannot extinguish,
call your fire
department.
Do not catl near the LP gas
tank because your telephone
is an electri-
cal device and could create a spark
resulting in fire and/or explosion.
NOTE: The normal flow of gas through the
regulator
and hose assembly
can create a
humming
noise. A low volume of noise is
perfectly normal and will not interfere with
operation
of the grill. If humming
noise is
loud and excessive
you may need to purge
air from the gas line or reset the regulator
excess gas flow device. This purging proce-
dure should be done every time a new LP
gas tank is connected
to your grill. For hetp
calt the Grill Information
Center.
Basic Lighting Procedures
1. Famitiadzeyourselfwiththesafetyguidetinesat
the front of this manual. Do not smoke while
lighting grill or checking gas supply connections.
2.
Be sure the LP gas tank is filled.
3.
Check that the end of each Burner Tube is properly
located over each Valve Orifice.
4.
5.
Make sure alt gas connections are securely
tightened.
Open the Grill Lid or Side Burner during lighting,
depending on the burner you are lighting.
WARNING
Failure
to open Grill Lid during
the
lighting
procedures
could result in a fire
or explosion
that could cause serious
bodily injury, death, or property
damage.
.
Set Control Knobs to OFF and open the LP gas
tank valve slowly until 1/4 to 1/2 open.
Open LP
gas tank
l
-"--
OFF
Never test for leaks with a flame.
Prior to first
use, at the beginning of each season, or every
time your LP gas tank is changed,
you must
check for gas leaks. Follow these four steps:
1. Make a soap solution by mixing one part
liquid detergent
and one part water.
2. Turn the grill Control Knobs to the full OFF
position,
then turn the gas ON at source.
3. Apply the soap solution
to all gas
connections.
If bubbles appear in the soap
solution the connections
are not properly
sealed. Check each fitting and tighten or
repair as necessary.
4. If you have a gas leak that cannot be
repaired by tightening,
turn off the gas at the
source, disconnect
fuel line from your grill and
call 1-800-4-MY-HOME (_ or your gas supplier
for repair assistance.
_J
7. Push and turn the LEFT Control Knob to HIGH.
l
HIGH
OFF
8. Immediately
press the Electric Ignitor for 3-4
seconds
to light the Burner.
PRESS
9. If ignition does not occur in 5 seconds, turn the
burner control(s) off, wait 5 minutes, and repeat the
lighting procedure.
10. Once the left grill burner is ignited, the adjacent
burner can be lit by simply turning its Control Knob
to HIGH.
11. Adjust Control Knobs to your desired cooking
temperature.
17
Advertisement
Table of Contents
