Lighting Stick Qty; Ref, # P05313023B; Qty. 2 - Kenmore 141.16223 Owner's Manual

H Be sure bothCastersare locked,thenwith the assistance of anotherperson,turn the
assembled grill upright.
H Installing Grease Draining Tray
Kit
1. Position Grease Draining Tray Heat Shield into slots in Grease Draining Tray. See W
2. From the back side of Grill Head install the Grease Draining Tray and Grease Draining Tray
Heat Shield. The Grease Draininq Tray Heat Shield is required to be present and
centered for your safety.
3. Insert two M4x8mm Pattern Head Screws into the threaded holes on the Left & Right Bowl
Panel, but do not completely tighten them yet. Slide the slotted holes on the Bow[Wind
Shield onto the two screws and then tighten firmly. See
4. From the front side of cabinet, install the Grease Receptacle under Grease Draining Tray. See
Pattern Head Screw M4xSmm
Qty. 2
Ref. # $132M04082
H Installing Lighting Stick
1. Attach the Lighting Stick to the Left Bowl Support Bracket as shown.
2. Align the hole at the end of Lighting Stick Wire with the threaded hole on the Left Bowl Sup-
port Bracket. Hand tighten using 1 screw. For instructions on manually lighting your grill by
match, refer to page 18.
Lighting Stick
Qty. 1
Ref. # P05313023B
Pattern Head Screw M4x8mm
Qty, 1
Ref. # $132M04082
J
12