Table of Contents
Advertisement
_!
Ignitor
Battery
Installation
1. Remove the Ignitor Cap located on the grill
Control Panel.
2. Place the manufacturer
supplied AA battery
into the Ignitor Slot. Be sure to place the
positive pole facing toward you.
3. Place the Cap and Spring over the AA battery
then tighten the Ignitor Cap onto the grill
Control Panel.
4. Remove any protective film from outside and
inside of Grill Head.
AA BATTERY
IGNITOR _'_"
SPRING
IGNITOR
SLOT
_'_
Electrode
Check
- Requires
an
Assistant
Before placing the cooking components
into your
grill, ensure that the Spark Electrode Tip is propedy
positioned within each Gas Collector Box (a
3-1/4" wide stainless mechanism found at the front
between each set of Burners.) The easiest way to
ensure this is to perform this Electrode Check:
1.
Be sure all Control Knobs are set to "OFF"
and open the Grill Lid.
2.
Have an assistant
stand behind to the right of
the grill and look down at each Gas Collector
Box. NEVER put your face inside Grill Head.
3.
Press the Ignitor Cap. You should hear a
"clicking"
sound and your assistant
should see
a small blue spark within each Gas Collector
Box. If a spark is present the Electrode
Tips
are properly positioned.
4.
If no spark is seen, the Spark Gap, as shown
below, needs to be adjusted
as follows:
.
Using an adjustable wrench, loosen the Inside Nut
just until the Gas Collector Box can be maneuvered
and turned upward.
The gap between the Spark Electrode Tip and
Spark receiver should be approximately 3/16".
If the gap is wider than 3/16" use a pair of long
nose pliers and gently squeeze the Gas Collector
Box until the gap is correct.
Return the Gas Collector Box to its odginal
hodzontal position, secure the Inside Nut and try
the Electrode Check again.
If no "clicking"
sound is heard check the
following common
causes. If you need
assistance
call the Grill Information
Center
at 1-888-317-7642.
•
Ignitor AA battery not installed propedy.
Electric wires may be loose. Remove the AA
battery, inspect the Ignitor Junction Box found
behind the Control Panel, and connect any loose
wires.
GAS COLLECTOR
BOX
INSIDE NUT
SPARK RECEIVER
15
Advertisement
Table of Contents
