Battery Replacement - Pride Mobility Go-Chair Owner's Manual

V I I I .
Wheel Replacement
If the drive wheels are equipped with a solid tyre insert, then
you must replace the whole wheel assembly. Replacement
wheel assemblies are readily available through an authorised
Pride Provider.
WARNING! To avoid possible injury, be
sure that the controller’s power is turned
off and the Go-Chair is not in freewheel
mode before performing this procedure.
To replace the wheel:
1. Turn off the power to the controller.
2. Set the Go-Chair up on blocks.
3. Remove the drive wheel nut from the wheel hub. See figure 20.
4. Pull the wheel off the axle.
5. Slide the new wheel back onto the shaft. Make sure that the
key is in the axle slot.
6. Reinstall the drive wheel nut onto the wheel hub and tighten.
7. Remove the Go-Chair from the blocks.

Battery Replacement

A battery wiring diagram is printed on a decal located on the
front battery tray. See the specifications table for correct
battery specifications.
WARNING! Prevent injury. Do not replace
battery when seat is occupied.
WARNING! Battery posts, terminals, and
related accessories contain lead and
lead compounds. Wear goggles and
gloves when handling batteries and wash
hands after handling.
WARNING! Go-Chair batteries are heavy.
See specifications table. If you are
unable to lift that much weight, be sure
to get help. Lifting beyond your capacity
can result in personal injury.
To replace the batteries:
1. Remove the battery box from the Go-Chair.
2. Turn the box upside down.
3. Remove all screws that hold the battery box halves together.
See figure 21.
4. Flip the battery box back over so the handle is up and remove
the lid.
5. Remove the red (+) positive and black (-) negative battery
leads from each battery.
32
C A R E A N D
www.pridemobility.com
M A I N T E N A N C E
Figure 20. Go-Chair Drive Wheel
Figure 21. Go-Chair Battery Box
Go-Chair