Input Check (Sp 5803) - Ricoh D096 Service Manual

5.2.4 INPUT CHECK (SP 5803)

- Conducting an Input Check -
1. Select SP 5803.
2. Select the number (see the table below) corresponding to the component.
3. Select "Execute." The copy mode is activated.
4. The sign "01H" or "00H" show (see the table below).
- Input Check Table -
Num. Sensor/Switch
001 Safety SW
002 Safety SW-LD 5V
003 Right Cover SW
004 Right Low Cover SW
005 Tray Cover SW
006 Upper Relay S
007 Lower Relay S
008 Vertical Trans S
009 Registration Sensor
010 Exit Sensor
011 Duplex Inverter S
012 Duplex Entrance S
013 Duplex Exit S
014 By-pass PE S
015 By-pass P Size S
016 Upper PE S
SM
01H
Open Closed
Open Closed
Open Closed
Open Closed
Open Closed
Paper detected Not detected
Paper detected Not detected
Paper detected Not detected
Paper detected Not detected
Paper detected Not detected
Paper detected Not detected
Paper detected Not detected
Paper detected Not detected
Paper detected Not detected
*1
Paper detected Not detected
5-7
Using SP Modes
00H
D096