Power up and test
·
Ensure the main AC power source plug is fitted with a 3A fuse.
Switch on
· Power up the system by inserting the main AC power source plug.
· Wait for the system power up routine to be complete. This can take up to 30 seconds.
Check that the vital activity LED is flashing. This is the top LED of the four LEDs in the CCU MDF
area.
· Make sure the Power LED is continuously lit. This is the third LED in the CCU MDF area.
Getting Started
1.
Remove any anti-scratch protective film from the ECX 1000 and ECX 2000 digital telephone LCDs
(Liquid Crystal Display).
2.
Label all digital telephone programmable keys and other telephones.
3.
Reset the system to default.
4.
Ensure that all digital telephones provide dialing tone, ringing and handsfree (loud speaking) facilities.
Check that the display is not showing corrupt information.
5.
Check that all other telephones are connected. Make sure all these phones ring and that you can dial
from them.
52
EncoreCX
Installation & Maintenance Manual