Table of Contents
Advertisement
Step 4. Positioning, Leveling, and
Securing the Fireplace
The diagram below shows how to properly position, level,
and secure the fireplace.
NAILING TABS
(BOTH SIDES)
Figure 25. Proper Positioning, Leveling, and
Securing of a Fireplace
1. Place the fireplace into position.
2. Level the fireplace from side to side and from front to
back.
3. Shim the fireplace with non-combustible material, such
as sheet metal, as necessary.
4. Secure the fireplace to the framing using nails or screws
through the nailing tabs. Holes are provided in the base-
pan (inside the hearth) for securing to the floor.
Step 5. The Gas Control Systems
WARNING: THIS UNIT IS NOT FOR USE WITH
!
SOLID FUEL.
Intermittent Pilot Ignition (IPI) System
The gas control system used with this model is Intermittent
Pilot Ignition (IPI). This system includes a 3V control valve,
electronic module, and intermittent pilot.
WARNING: CONTINUOUS 110-120 VAC SER-
!
VICE MUST BE WIRED TO THE FIREPLACE
JUNCTION BOX.
Figure 26. Intermittent Pilot Ignition
26
Advertisement
Table of Contents
