Radion Smoke - Bosch ICP-EZM2 System Reference Manual

Easy Series Control Panel
Figure 8.4: Walk test
1.
2.
3.
4.
8.11

RADION smoke

The RFSM is a non-latching wireless smoke detector that sends an alarm signal to the receiver.
The following features include:
–
–
–
Replaceable optical chamber
Power/voltage
Current draw
Battery replacement
Battery life
Device testing
Sensitivity
Bosch Security Systems, Inc.
Start at the pattern's expected boundary and walk across the pattern moving closer to
the detector (refer to the Walk test figure above).
While the detector is in the Walk Test Mode, turn ON all heating and air conditioning
sources which would normally be active during the protection period. Stay away from the
sensor and outside the coverage pattern and watch for alarms.
The LED flashes at the completion of a 90-sec span of time, indicating that the Walk Test
mode is ending. This occurs when there is no activity in the sensor's coverage pattern
during the 90-sec interval.
When walk testing is completed. the detector returns to normal operation after 90
seconds of inactivity.
A visual status LED
A built-in sounder for alarm alerts
Under normal conditions, the red LED flashes once every 8 sec while the sensor monitors
the surrounding environment. When the sensor detects smoke, the LED changes from
flashing to steady ON and the sounder produces a loud, continuous tone. Refer to the
LED table for more information.
System Reference Guide
Device Specifications and Overview | en
For easy maintenance
Two CR123A Lithium batteries, 3 VDC (
Power source type: C
Low battery level: 2.15V
Standby: 45 uA
Alarm: 70 mA
Duracell DL123A, Panasonic CR123A, or Sanyo CR123A.
Check your batteries yearly to ensure proper
functionality.
Minimum of 5 years or greater
To ensure proper functionality, the device must be tested
at least once every year.
0.14+/- 0.04 bM/m (0.97 – 2.99%/ft obscuration – RFSM-
A only)
87
)
2014.09 | 01 | F.01U.306.221