BATTERY
SPECIFICATIONS
Type designation
Capacity
Standard electrolyte S.G.
a Anode plates
b Separator (fiberglass plate)
c Cathode plates
d Upper cover breather
INITIAL CHARGING
FILLING ELECTROLYTE
• Remove the aluminum tape 1 which seals the battery filler
holes 2.
NOTE:
When filling electrolyte, the battery must be removed from the
vehicle and must be put on the level ground.
• Remove the caps 3 from the electrolyte container.
NOTE:
* After filling the electrolyte completely, use the removed cap 3
as sealing caps of battery-filler holes.
* Do not remove or pierce the sealed areas 4 of the electrolyte
container.
• Insert the nozzles of the electrolyte container 5 into the bat-
tery's electrolyte filler holes. Hold the electrolyte container
firmly so that it does not fall. Do not allow any of the electro-
lyte to spill.
YTX9-BS
12 V, 28.8 kC (8 Ah)/10 HR
1.320 at 20 °C
e Stopper
f Filter
g Terminal
h Safety valve
ELECTRICAL SYSTEM
6-49