Processing Errors - Ricoh FT5540 Service Manual

4.3 Processing Errors

Reference Line
If the referrence line dows not reach the mark detection sensor within 2.6 seconds after the
job sheet is fed in, the job sheet is fed out. (Feeding out takes 1.6 seconds.) The red light
blinks for 6 seconds; then, the job sheet can be reinserted.
Reference Mark
If the mark detection sensor detects the reference line and then fails to detect a reference
mark within 0.2 seconds, or if it fails to detect a reference mark within 0.1 seconds, the job
sheet is fed out and the red light blinks for 6 seconds; then, the job sheet can be reinserted.
Note: Occasionally, the job sheet feeds out to the rear side of the menu reader after a
failure to detect the reference mark number.
Marking
When two or more selections are made for the same item, the menu reader cannot process
the job sheet and the red light blinks (indicating an error).
Note: 1. When an item is not marked on the job sheet, the menu reader automatically
reads as follows:
2. The job sheet may jam inside the menu reader if it is smaller than the specified
size.
Caution: Sensors were set at the factory and cannot be adjusted in the field.
- Item -
Copy Quantity
Reproduction Ration
- Indicator -
1
100%
12-7
31 August 1989