Tire Changing - Chevrolet 2010 Traverse Owner's Manual

Hide thumbs Also See for 2010 Traverse:

Table of Contents

Vehicle Care

1. Press down on the latch tab and

pull the cover off to access the

storage compartment.

2. Press the two tabs on the quick

release buckle to release the tire

sealant and compressor kit

3. Remove the sealant and

compressor kit from its tray.

To store the tire sealant and

compressor kit, reverse the steps.

Tire Changing

Removing Tools

The tools needed to remove the

spare tire are located in the storage

compartment on the driver side, at

the rear of the vehicle.

1. Open the jack storage

compartment by pulling on the

latch tab, located toward the rear

of the vehicle, and pulling the

B. Wing Bolt

2. Remove the wing bolt (B) by

turning it counterclockwise

3. Push the jack (C) up out of the

holding bracket.

4. Turn the jack on its side, with the

bottom facing toward you.

5. Pull the jack straight out, bottom

Table of Contents