Symbol VRC 8900 Product Reference Manual page 58

VRC 8900 Radio Terminal Product Reference Guide
2. Under Adapters, select SLACE1: Spectrum24 WLAN Driver, and tap
Properties.
3. Use the IP Address tab in the Spectrum24 WLAN Driver Settings screen to view
and adjust the IP address, subnet, and gateway.
Figure 5-2. Spectrum24 WLAN Driver Settings Screen - IP Address Tab
If you select Obtain an IP address via DHCP, DHCP (Dynamic Host Configuration
Protocol) obtains a leased IP address and network configuration information from
a remote server. An access point sends out a DHCP request searching for a DHCP
server to acquire the network configuration and firmware filenames.
If you select Specify an IP address, enter the following fields:
• IP Address: A 32-bit (max) number (expressed in dotted-decimal notation
157.235.90.24) that the Domain server uses to transmit and receive data. The
IP address of the adapter is required to be in the same subnet as that of the
access point for the devices to interoperate in Infrastructure mode.
• Subnet Mask: Required in order for the subnet to exist. Its purpose is to mask
out IP addresses that are not part of the subnet. The network administrator
usually has the required subnet mask.
• Default Gateway: Used to connect to the corporate network. The network
administrator usually has the IP address required for the default gateway.
5-2