Symbol VRC 8900 Product Reference Manual page 29

6. Place a fuse holder in-line of the brown and blue wire approximately 4 inches from
the cable end, as shown below.
Fuse Holder
Solder the fuse terminal ends to the wire to ensure a proper electrical connection.
7. Connect the brown wire to the vehicle's positive power source. Connect the blue
wire to the vehicle's negative power source. To terminate the cable:
• If the vehicle has a power output connector, use a mating connector. You may
be able to connect to a fuse panel with a commercially available connector.
• If the vehicle has no power output connector, use a ring terminal (for a battery
post) or blade terminal (for a fuse panel).
See your vehicle Owner's Manual for more information.
Ensure the wiring connections created are sufficiently insulated from each other.
8. Re-connect the electric truck battery.
9. Insert the cable's DC power connector into the terminal's DC power port. Align the
keyway on the power connector with the notch on the terminal's power port.
A lead acid battery can leak hydrogen gas. A spark any-
where near the battery can cause it to explode. Always
make your final connection to power as far away from the
battery as possible, i.e., connect the power cable to the
battery first, then the terminal.
Fuse Terminal Ends
Spring Fuse
W
ARNING
Installing the Terminal
Fuse Holder
2-11