Installation
Connecting the BOA Vision System
This section details how to connect the BOA vision system with its associated
components and factory environment.
Camera Connectors and Indicators
Designator
LAN
I/O PWR
LAMP
LAN LED
LED2
LED1
Version 02
Definitions
10/100 BaseT Ethernet connection. Provides the primary
interface for configuring the camera, developing the application
and monitoring results.
NOTE: The camera can be powered from the Ethernet cable
directly (Passive Power over Ethernet)
Provides access to the camera I/O – 2 IN, 2 OUT Opto. Also
provides PWR input (12-30V).
Provides PWR and strobe control to a local LED light source.
NOTE: Lamp PWR is identical to BOA PWR input. The camera
should be powered from a 12V PWR source if the light requires
a 12V supply (Recommend 24V supply)
Red/Green/Yellow = Network activity
Blue = Warm Reset
Blue blink = Booting (stops after about 20 seconds)
Green Solid = Inspection Running
Red = Inspection Halted
Blue Solid = Camera booted, not configured
Green Solid = Inspection Running
Red Solid = Inspection Halted
teledynedalsa.com/ipd
8