Table of Contents
Advertisement
Ethernet and I/O Setup with Lamp
1.
Connect the M12-8 male end of the Ethernet cordset (A-BVS-E8S-X) to the M12-8
female connector labeled "LAN" on the camera.
2.
Connect the RJ45 end of the Ethernet cordset to the RJ45 connector labeled
"CAM LAN" on the Panel Link breakout module (A-BVS-PL-100)
Connect the RJ45 labeled "LAN" on the breakout module to the controlling PC,
3.
PLC or the factory LAN
4.
Connect camera PWR, GND and I/O from the control panel to the breakout screw
terminals.
5.
Connect the M12-8 male end of the IO-PWR cordset (A-BVS-IO8S-X) to the M12-
8 female connector on the camera labeled "I/O PWR"
6.
Connect the open-ended wires of the IO-PWR cordset to their respective
connections on the breakout module.
Setup Computer, PLC
or Factory Network
Version 02
A-BVS-PL-100
Cat5 Cable
LED Lamp
teledynedalsa.com/ipd
A-BVS-E8S-X
BOA System
A-BVS-L5S-X
A-BVS-IO8S-X
12
Hide quick links:
Advertisement
Table of Contents
