[Cm94] Multiline Terminal One-Touch Memory - NEC NEAX 2000 IVS Command Manual

CM94
COMMAND CODE
94
MAT
1. FUNCTION:
This command is used to assign memory for the storage of numbers accessed by the one-touch keys on a
Multiline Terminal.
2. PRECAUTION:
This command is included in MAT mode menu "A2" (D
3. ASSIGNMENT PROCEDURE:
ST + 94 +
4. DATA TABLE:
MY LINE NUMBER
X
XXXX
Note 1: If "4" is selected, the first 10-Slot Memory Block number must be "00" through "49".
Note 2: 1000-Slots Memory Block Number 8-F can be used when the system provides the Extension Mem-
ory card. If assigning the station number to One Touch keys using this memory area, the lamp
does not show the busy state.
CHAPTER 3
Page 302
Revision 2.0
[CM94] Multiline Terminal One-Touch Memory
TITLE:
MULTILINE TERMINAL ONE-TOUCH MEMORY
PRIMARY
EXTENSION
DE + +
NUMBER
(1 – 4 digits)
DATA
XXXXXX
term
Key [COM01]).
DATA
DE + + EXE
(6 digits)
SETTING DATA
X XX X XX
ND-45669 (E)
MEANING
Quantity 10-Slot Memory
Blocks (01/02)
01:Multiline Terminal (10 memories)
02:Multiline Terminal (20 memories)
Facility for programming the
dialed number from the station
(0/1 = Effective/Ineffective)
First 10-Slot Memory
Block (00-99)
The 1000-slots memory Block num-
ber (0-4, 8-F) Note 1, Note 2