Table of Contents
Advertisement
Connector
Figure 19. Upper Inside View of the Cabinet Model Showing Cable Connector Attachment
6. Pull the cable up through the notch until it reaches the I/O plate.
7. Attach the cable connector to the desired printer interface connector as
|
|
8. Secure the cable to the printer using the upper and lower cable standoffs.
|
9. Guide the power cable up through the hole in the lower right back
|
10. Thread the power cord inside the bracket where the gas spring is
11. Plug the power cord into the printer AC power connector, then into the
|
|
|
|
12. Turn the printer on.
13. Continue with "Install the Ribbon and Paper" on page 24.
|
I/O Connector
Cable
shown in "Interface Connections (Cabinet and Pedestal)" on page 22.
corner of the cabinet (see Figure 15 on page 18).
attached.
AC power outlet.
IMPORTANT: Printer power should be supplied from a separate AC
circuit protected at 10 amperes for 100-120 volts or 5
amperes for 200-240 volts at 50 or 60 Hertz.
Connect the Interface and Power Cables
I/O Plate
Basic Operating Procedures
21
Advertisement
Table of Contents
