Canon LV-WX300 User Manual page 64

10. Place the lamp protection film supplied with the new lamp
on the lamp compartment.
11. As shown in the figure, replace the lamp cover on the
projector.
12. Tighten the screws that secure the lamp cover.
• Loose screw may cause a bad connection, which could
result in malfunction.
• Do not over tighten the screws.
13. Restart the projector.
Do not turn the power on with the lamp cover removed.
Resetting the lamp timer
14. After the startup logo, open the On-Screen Display (OSD)
menu. Go to the SYSTEM SETUP: Advanced > Lamp
Settings menu. Press OK/IMAGE. The Lamp Settings
page is displayed. Press
and press OK/IMAGE. A warning message is displayed
asking if you want to reset the lamp timer. Highlight Reset
and press OK/IMAGE. The lamp time will be reset to '0'.
Do not reset if the lamp is not new or replaced as this could cause damage.
64
to highlight Reset lamp timer
2
1
Notice
Reset Lamp Time ?
Reset
Cancel