Table of Contents
Advertisement
7. Place the flat panel monitor power supply, which came with your flat panel monitor, inside the monitor
stand. If necessary, insert the power supply spacer 3 behind the power supply and over the cable
to keep the power supply in place.
Figure 8. Storing the power supply and routing cables
8. Connect the power supply to the monitor and route the cable under the tab near the top of the monitor
stand 1 ; then, secure the power cable with the cable clamp you removed from the original stand and
coil excess cable inside the monitor stand.
9. Connect the monitor signal cable to the monitor and route it under the tab in the bottom of the monitor
stand 2 and out the back of the stand through the hole provided.
10. Replace the monitor stand cover 1 .
Figure 9. Installing the cable cover, hinge cover, and stand cover
11. Snap the new hinge cover 2 into place over the hinge assembly.
Note: Be sure to use the new hinge cover that comes with the Flat Panel Monitor Rack Mount Kit II
because it has deeper grooves to accommodate the new hinge assembly.
New hinge cover
Figure 10. Comparing the new hinge cover to the old hinge cover
12. Snap the cable cover 3 into place on the back of the flat panel monitor.
Old hinge cover
Installing the new monitor stand
7
Advertisement
Table of Contents
