Table of Contents
Advertisement
13. Fold the flat panel monitor down until it rests on the rubber bumpers; then, gently push back and
remove the small cable exit cover 1 on the monitor stand.
Figure 11. Routing the keyboard cable
14. Route the space-saver keyboard cable through the hole in the front of the base and out the opening in
the back where you removed the small cover; then, place the keyboard (with its adjustable feet fully
down) inside the keyboard tray.
Note: You must open the flat panel monitor to its full upright position so that you can install the
keyboard and route its cable.
15. Fold the flat panel monitor down again until it rests on the rubber bumpers; then, reinstall the small
cable exit cover 1 .
16. Slide the keyboard tray into the rack cabinet; then, neatly route and secure all cables in the rack
cabinet using the provided cable straps.
You can now connect the power cord to the flat panel monitor and connect the display to a server. If
you have an optional console switch, you can install it now as shown in "Installing an optional console
switch" on page 9.
8
Flat Panel Monitor Rack Mount Kit II Installation Instructions
Advertisement
Table of Contents
