Assembly; Header Plate (23) From The Weight Guides - NordicTrack E 8500 User Manual

ASSEMBLY

1. Note: Assembly requires two persons. For
clarity, some parts are not shown.
Place all parts in a cleared area and remove the
packing materials; do not dispose of the pack-
ing materials until assembly is completed.
Attach the Left Rear Frame (9) to the Center
Frame (1) with four M10 x 25mm Screws (73).
Next, tighten a Leveling Foot (44) into the Left
Rear Frame. Attach the Right Rear Frame (8)
and the other Leveling Foot (44) in the same
way. Make sure that the Leveling Feet, the
Frame Feet (45), and the Wheels (not shown)
are all level with the floor (see page 6).
2. Loosen the two Weight Guides (22) from the top
of the Center Frame (1). Then, remove the

Header Plate (23) from the Weight Guides.

Next, locate the Weight (25) with the highest
number decal. Orient the Weight so that the num-
ber decal is right-side-up. Then, slide the Weight
onto the Weight Guides (22). Slide the remain-
ing Weights (25) onto the Weight Guides in
the same way.
Slide the Header Plate (23) onto the Weight
Guides (22). Next, insert the Weight Selector (26)
into the Weights (25). Then, tighten the Weight
Guides into the top of the Center Frame (1).
3. Make sure that all parts are properly tightened. The use of the remaining parts will be explained in ADJUST-
MENT, beginning on page 6. Before using the weight system, pull each cable a few times to make sure that
the cables move smoothly. If one of the cables does not move smoothly, find and correct the problem.
IMPORTANT: If the cables are not properly installed, they may be damaged when heavy weight is
used. See page 9 for proper cable routing. If there is slack in the cables, you will need to tighten the
cables. See MAINTENANCE on page 10.
1
45
2
5
9
8
73
44
44 73
73
1
45
1
23
26
22
22
Pin
Hole
25
Number
Decal