Setup And Operation; Step 1: Install Batteries; To Replace Batteries - Honeywell 2202 User Manual

SETUP & OPERATION

STEP 1: INSTALL BATTERIES

IMPORTANT: The starter batteries included with this product are for testing
purposes only and should be immediately replaced with new alkaline or lithium
batteries. It is NOT RECOMMENDED to use Non-alkaline or rechargeable
batteries.
1. The battery compartment is located
behind round digital keypad housing.
To gain access, turn the housing to the
left (counterclockwise) and carefully
pull forward and down.
2. Insert 4 "AA" batteries (included).
Ensure the batteries are installed in
the correct direction, with regard to
polarity (+ and -).
3. Re-install battery compartment cover
by inserting into the locking holes and
turning housing to the right (clockwise).

TO REPLACE BATTERIES:

Weak or dead batteries should be replaced immediately and all 4 batteries
should be changed. To replace the batteries please follow the instructions in
the SETUP section. Remember to always remove batteries from safe if not
using for an extended period of time. If your batteries are completely dead
and you cannot open the safe by using the digital keypad, use the override
access key to open safe and access the battery compartment.
IMPORTANT: When the batteries need replacing,
the small Red LED lamp will begin to glow. If the
batteries are fully discharged, the digital keypad will
not function and the batteries will need to be
replaced in order to gain access to the safe.
If the batteries are removed or fail, the keypad memory will NOT be erased
and the active programmed code will still work once power has been
restored.
1.
2.
3.
2