Table of Contents
Advertisement
Protection
Aggregation
Short GI
WLAN Partition
RF Output Power
It is recommended to enable the protection mechanism. This
mechanism can decrease the rate of data collision between 802.11b
and 802.11g wireless stations. When the protection mode is enabled,
the throughput of the AP will be a little lower due to many of frame
traffic should be transmitted.
Default is "Disabled".
It is a function where the values of multiple rows are grouped together.
Default is "Enabled"
It is used to set the time that the receiver waits for RF reflections to
settle out before sampling data.
Default is "Enabled"
This feature also called "WLAN isolation" or "Block Relay". If this is
enabled, wireless clients cannot exchange data through the
WNRT-300.
Default is "Disabled".
Users can adjust the wireless output power here.
Default is "100%".
-28-
User's Manual of WNRT-300
Advertisement
Table of Contents
