Table of Contents
Advertisement
Auto Setup for Windows 3.1, Windows 95, or Windows NT
If the monitor is in standby
mode (STANDBY ON), it
may automatically turn off while
you are waiting for it to warm up.
The size and diversity of
the color pattern varies
with the screen resolution.
If the screen flickers,
repeat the setup several
times until the flicker is
minimised,
Continued from Auto Setup for DOS on page 9
15
Drag the icon bar and tool bar, if they are displayed, to the bottom of the
screen
16. Insert the diskette labelled ' Setup Option Diskette (for DOS / Windows /
Windows NT)' into the diskette drive.
17. Check the operating system installed on your PC and follow the
instructions from the table below
.
Operating
Step 1
system
open
Windows 3.1
Program
Manager
open
Windows NT
Program
3.5
Manager
Windows 95 click on Start
click on Start
Windows NT
4.0
18. The color-bar pattern appears and auto setup starts.
19. Position the mouse pointer at the bottom center of the screen. This
allows auto setup to run properly.
20. The AUTO SETUP line changes to COMPLETED when auto setup is
completed.
If "AUTO SETUP COMPLETED" is not displayed, or the "AUTO SETUP FAILED"
message appears, repeat the auto setup procedure several times.
21. Press ALT+F4 to exit auto setup.
You have completed the monitor setup.
Step 2
click on File
click on File
click on Run
click on Run
10
Step 3
Step 4
click on run
Type
click on run
'A:\TESTPAT'
Advertisement
Table of Contents
