Table of Contents
Advertisement
Auto Setup for DOS
If the monitor is in standby
mode (STANDBY ON), it
may automatically turn off while
you are waiting for it to warm up.
If you are using PC-DOS/V,
change to U.S. mode by
typing 'CHEV US' and pressing
ENTER at the command
prompt.
If the screen flickers,
repeat the setup several
times until the flicker is
minimised,
1.
Turn on the monitor first; then the PC.
If the message UNSUPPORTED VIDEO is displayed, or if nothing is displayed
check:
•
that the video interface cable is connected properly.
•
the correct video adapter card is installed.
•
the correct supported display mode is selected for your PC.
2.
Wait approximately 15 minutes, until the monitor warms up.
3.
Insert the diskette labelled ' Setup Option Diskette (for DOS / Windows /
Windows NT)' into the diskette drive.
4.
Display the command prompt screen of the DOS full-screen display:
•
If Windows is installed, open the DOS prompt from the Program
Manager to display the DOS full-screen.
•
If OS/2 is installed, open the DOS full-screen display from the
command prompt of OS/2.
•
If only DOS is installed, the command prompt is displayed when the
system is started.
5.
At the command prompt, type 'A:' and press ENTER.
6.
Type 'TESTPATD' and press ENTER. The color-bar pattern appears.
7.
Push the setup switch at the bottom of the monitor. The setup menu
appears.
8.
Push one of the brightness control buttons
9.
Push one of the contrast control buttons
up; - moves the highlighter down). The AUTO SETUP line changes to
start, and auto setup starts.
10. Wait until the PRESS [ENTER] KEY message is displayed.
11. Press ENTER to continue the auto setup procedure.
12. The AUTO SETUP line changes to COMPLETED when auto setup is
complete.
13. Push the setup switch at the bottom of the monitor. The setup menu
disappears.
14. Type 'Exit' at the command prompt to return to Windows.
Now continue the setup for your operating system:
9
to select AUTO SETUP.
(+ moves the highlighter
Advertisement
Table of Contents
