Adjusting Volume; Setting The Time; Radio; Listening To Radio - Alpine CDE-135EBT Owner's Manual

3
Press RESET with a ballpoint pen or similar pointed object.
RESET switch

Adjusting Volume

Turn the Rotary encoder until the desired sound is
obtained.

Setting the Time

1
Press and hold AUDIO/SETUP for at least 2 seconds to
activate the SETUP mode.
2
Turn the Rotary encoder to select the GENERAL mode,
and then press ENTER.
BLUETOOTH  GENERAL  AUDIO  DISPLAY  iPod & USB
3
Turn the Rotary encoder to select CLOCK ADJ, and then
press ENTER.
The time indication will blink.
4
Turn the Rotary encoder to adjust the hours while the
time indication is blinking, and then press ENTER.
5
Turn the Rotary encoder to adjust the minutes while the
time indication is blinking.
6
Press and hold AUDIO/SETUP for at least 2 seconds to
return to normal mode.
Notes
• To synchronise the clock to another clock/watch or radio time
announcement, press and hold ENTER for at least 2 seconds after
setting the "hour". Minutes will reset to "00". If the display shows over
"30" minutes when you do this, the time will advance one hour.
• Press  to return to the previous mode.
• If no operation is performed for 60 seconds, the unit will return to
normal mode automatically.
Controllable with Remote Control
This unit can be controlled with an optional Alpine remote control.
For details, consult your Alpine dealer.
Point the optional remote control transmitter at the remote control
sensor.
Remote control sensor
Connectable to Steering Remote Control Interface Box
With an optional Alpine Steering Wheel Remote Control Interface
Box (not included), this unit is controllable from the vehicles
steering wheel controls. For details, contact your Alpine dealer.
8
-EN

Radio

SOURCE/
 
Rotary encoder/
BAND/F/R
TUNE/A.ME
* The illustration is for CDE-135EBT.

Listening to Radio

1
Press SOURCE to select TUNER mode.
2
Press BAND repeatedly until the desired radio band is
displayed.
F1 (FM1)  F2 (FM2)  AM  F1 (FM1)
3
Press TUNEA.ME to select the tuning mode.
DX SEEK (Distance mode)  SEEK (Local mode)  OFF (Manual
mode)  DX SEEK
Note
• The initial mode is Distance mode.
Distance mode:
Both strong and weak stations will be automatically tuned in
(Automatic Seek Tuning).
Local mode:
Only strong stations will be automatically tuned in (Automatic
Seek Tuning).
Manual mode:
The frequency is manually tuned in steps (Manual tuning).
4
Press  or  to tune in the desired station.
Holding down  or  will change the frequency
continuously.

Presetting Stations Manually

While receiving the station that you want to store, press
and hold, for at least 2 seconds, any one of the preset
buttons (1 through 6) into which you wish to store the
station.
The display shows the band, preset number and station
frequency memorised.
Notes
• A total of 18 stations can be stored in the preset memory (6 stations for
each band; FM1, FM2 and AM).
• If you store a station in a preset memory which already has a station,
the current station will be cleared and replaced with the new station.

/ENTER
Preset buttons
(1 through 6)