Gateway e-4000 User Manual page 123

5
Slide the drive out of the drive bay.
6
Set any jumpers on the new drive to match the old drive. See the drive
documentation for further instructions.
7
Slide the new drive in, then slide the release lever toward the inside of the
case.
8
Reconnect the drive cables using your notes from Step 3. The red-striped
edge of the data ribbon cable indicates Pin 1 and corresponds with Pin 1
on the drive (typically on the side closest to the power supply connection).
See the drive documentation for further instructions.
9
Close the case by following the instructions in "Closing the case" on
page 110.
www.gateway.com
Gateway Mid Tower Case
117